Bypass Emulator Detection for Blood Strike on Gameloop
1) Install Fresh Gameloop 64-bit (Click Here to Download)
2) Now search “Subway Surfers” or “Twitter” on Gameloop and install it (important), this is needed to install Engine files for emulator
3) After installed, go to Gameloop settings and enable ADB Debugging.
4) Now, open Subway Surfers or Twitter from Gameloop to start the emulator.
5) Download our BLOOD STRIKE installer for Gameloop: Click Here to Download
6) Extract the files, run Installer.exe and proceed with the game’s installation.
7) Once installed, Download our Bypass by clicking on “DOWNLOAD LOADER” from below
8) Extract the files, Run Pathfinder.exe or Pathfinder_Week.exe depending on your key and click on ENTER.
9) Click on START EMU to start Gameloop Emulator and wait for it to load.
10) Once loaded, click on START GAME and wait for game to load. Enjoy!
Blood Strike Emulator Bypass
BUY NOW
Loader Last Updated on 21st March for Blood Strike (v1.003.639271)
DOWNLOAD NOW
Changelogs for 21st March Update:
Note #1 – Updated for Blood Strike official launch v1.003.639271 
HOW TO USE ?: Read instructions from above, don’t ignore a single step !
